Advanced → Wireless Extender - TP-Link NC200 User Manual

2. Click Manually, and you will see the following screen.
3. In the Wireless Network Name field, enter the name of the wireless network to which your
camera is ready to connect.

Note:
The name must be exactly the same as that used in the wireless access point, or the connection
will not be established. Leaving this field blank means the camera will attempt to access the
nearest open network. If your PC wants to access the camera, make sure your PC and the camera
are connecting to the same wireless network.
4. Select the wireless security mode used by your wireless network from the drop-down list. The
security mode and its corresponding settings must be exactly the same as that used in the
wireless network.
5. Click Connect and a screen will pop up. Click Change on the pop-up screen.
6. Click OK on the pop–up screen to finish wireless connection procedure.
7. To start using camera wirelessly, unplug its Ethernet cable.
3.4.4 Advanced → Wireless Extender
On this page, you can setup and configure the wireless network extending feature of your camera.
Wireless extender function allows your camera to extend the range of your existing wireless
network. The same network name and settings as the existing wireless network can be used, or
you can create a new one.
The camera's wireless extender function is disabled by default. If you want to use this function, just
select the Enable option.
NC200 Cloud Camera, 300Mbps Wi-Fi
22