TP-Link NC200 User Manual page 34

Username: Enter the username that is used to log in to your FTP server.

Password: Enter the password that is used to log in to your FTP server.

Path: Enter the path to the destination on the FTP server.

Passive Mode: Enabling passive mode may help you reach your FTP server if your camera is

behind a router protected by a firewall.
To set up a FTP to receive notification, follow the steps below:
1. Enter an IP address or domain of your FTP server, e.g. 192.168.1.168
2. Remain the FTP port number as the default value: 21.
3. Enter your username to log in to the FTP server, e.g. test.
4. Enter your password to log in to the FTP server.
5. Enter the path to the destination on the FTP server, e.g. /test
Enable Passive Mode.
6.
7. Click Save to save and enable the settings.
Click Test, and a test JPEG snapshot will be sent to the specified FTP server to check whether
your settings are correct.
If the settings are tested correct, you will see the following screen. Click OK.
NC200 Cloud Camera, 300Mbps Wi-Fi
28