TP-Link NC200 User Manual page 26

PPPoE: To enable or disable the PPPoE service here.

Status: Displays the PPPoE connection status.

Username: Enter the username for PPPoE service provided by your ISP.

Password: Enter the password for PPPoE service provided by your ISP.

HTTP (Hypertext Transfer Protocol)
This feature allows you to access and manage your camera via its IP address. Web browser
access normally uses the standard HTTP service port 80. The camera uses HTTP port 80 by
default. For greater security, you can change the port to a custom one.
When HTTP port is set to 80, you can access the camera by typing its IP address (for example,
http://192.168.1.100) on a web browser. When HTTP port is set to another value (for example,
2000), you need to type http://192.168.1.100:2000 instead.
HTTP Port: The default value is 80. If you want to use a port number other than 80, enter a

port number between 1 and 65535.
UPnP (Universal Plug and Play)
This function permits the camera to be seamlessly discovered by networked
establishes functional
UPnP Port Forwarding: To enable or disable the UPnP Port Forwarding service here. If this

function is enabled and your router supports UPnP, the cameras and router can communicate
with each other so that the router knows which ports are used by which camera.
UPnP Name: Displays the camera name.

Bonjour
Bonjour, also known as zero-configuration networking, enables automatic discovery of computers,
devices, and services on IP networks. Bonjour uses industry standard IP protocols to allow
devices to automatically discover each other without the need to enter IP addresses or configure
DNS servers.
network services for data sharing, communications, and entertainment.
NC200 Cloud Camera, 300Mbps Wi-Fi
20
devices and