Evinrude B10R4 Operator's Manual page 62

62 INSPECTION AND MAINTENANCE
!
You may be injured due to high engine
temperatures if you fill engine oil just
after stopping. Changing engine oil
should be done after the engine has
been cooled.
!
● Do not overfill engine oil, or engine
oil could leak and/or engine could be
damaged. If engine oil level is over
upper limit marks of oil gauge, drain
oil to level lower than upper limit.
● Be sure that outboard motor is in up-
right and level position when check-
ing or changing oil.
● Stop engine immediately if low oil
pressure warning lamp is lit or oil
leak is found, or engine could be
severely damaged. Consult dealer.
Notes
● If any amount of water is found in
engine oil, making it milky white,
consult dealer.
● If engine oil is contaminated with
10
fuel, emitting strong fuel smell,
consult dealer.
CAUTION
CAUTION
Cleaning the fuel filters and the
fuel tank
Fuel filters are located inside the fuel
tank and engine.
WARNING
!
Gasoline and its vapors are very flam-
mable and can be explosive.
● Do not start this procedure while
engine is operating or hot even after
stopping it.
● Place fuel filter away from every
source of ignition such as sparks or
open flames.
● Wipe off gasoline well immediately if
spilled.
● Install fuel filter with all related parts
in place, or fuel leak could occur,
leading to catching fire or explosion.
● Check fuel system regularly for leak-
age.
● Contact an authorized dealer for
fuel system services. Services by
unqualified person could lead to
engine damage.
■ Fuel filter (for engine)
① Replace the filter provided inside
of engine cover if there is water or
dirt inside.
Fuel filter