Overview of Network Setup and Configuration
To set up and configure over the network:
1. Connect the printer to the network using the recommended hardware and cables.
2. Turn on the printer and the computer.
3. Print the Configuration page and keep it for referencing network settings.
4. Set the printer's IP address. To do this, see
5. Install the driver software on the computer from the Software and Documentation
6. Print a Configuration page to verify the new settings.
Note:
latest driver from www.xerox.com/drivers.
Downloaded From ManualsPrinter.com Manuals
Address
on page 36.
CD-ROM. For information on driver installation, see the section in this chapter for the
specific operating system you are using.
If the Software and Documentation CD-ROM is not available, you can download the
Overview of Network Setup and Configuration
Dynamic Methods of Setting the Printer's IP
Phaser® 6280 Printer
32