Parallel Interface Connection - Kyocera FS-1050 Installation Manual

Parallel Interface Connection

To printer
Printer Cable
USB (Universal Serial Bus) Interface Connection
To printer
USB Cable
1
Plug one end of the printer cable (not
included) into the parallel interface con-
nector on the rear of the printer.
Clips
2
Close the clips on both sides to fix the
connector in place.
Plug the other end of the printer cable
into the computer's Centronics parallel
interface connector.
1
Plug one end of the USB cable on the
rear of the printer.
2
Plug the other end of the USB cable into
the computer's USB interface connec-
tor.
• Use a parallel printer cable
that complies with the
IEEE1284 standards.
• The printer will work best if it
is installed near the computer.
The connecting cable should
be shielded and not be longer
than 3 meters (10 feet).
• Use a cable that complies
with Revision 1.1 of USB stan-
dard.(a rectangular Type A
plug and a square Type B
plug).
• The connecting cable should
be shielded and not be longer
than 5 meters (15 feet).
7