Step 5 Connecting To Power; Power Requirements - Kyocera FS-6020 Installation Manual

STEP STEP
Connecting to Power
5
This section describes the procedure for connecting the power cord and various cau-
tions.
Notes on Power Supply
• Install the printer near an AC wall outlet, preferably one that can be used for
the printer alone.
• Only use this printer with the supply voltage indicated on the serial number
label attached to the printer's rear panel.
• If an extension cord is used, the total length of the power cord plus extension
should be 5 meters (16 feet) or less.

Power Requirements

Voltage
Frequency
Current capacity
To Connect the Power Cord
• Be sure the printer's power switch is turned off.
• Only use the power cord supplied with the printer.
8
220 to 240 V, ±10 %
50/60 Hz (220 to 240V) ±2 %
Max. 3.8 A at 220 to 240 V
1
Plug the power cord into the power cord
Power Cord
connector on theear of the printer.
Connector
2
Connect the other end of the power cord
into a power outlet.
Power Cord
Be sure to connect to a 3-wire
grounded power strip.