8-Connect The Printer To The Computer; 9-Attach The Power Cord; Parallel Interface; Serial Interface - Kyocera FS-1750 Installation Manual

8—Connect the Printer to the Computer
The printer has two computer cable connectors and a slot for installing an option interface.
The one marked "
"IOIOI" is for a serial (RS-232C/RS-422A) interface. You may use whichever is convenient
for your computer, with the option interface, if you have already have one installed. All
interface connectors can be used simultaneously with different computers.
Serial (RS-232C/RS-422A)
Interface Connector

Parallel Interface

Connector
Only connect or disconnect cables to the connectors while the printer and computer
power are switched off.
Parallel interface
Plug one end of the cable into the connector
marked Parallel on the printer. Close the clips on
both sides to hold it in place.
Plug the other end into a parallel (Centronics)
interface connector on your computer. This con-
nector is usually marked PRINTER.
For more details about the parallel interface, see
Appendix C in the User's Manual (PDF file) pro-
vided on the Kyocera Digital Library CD-ROM.

Serial interface

The serial interface of this printer is set to RS-232C mode before leaving the factory, but can
also be set to RS-422A mode to suit your operating environment. Follow the instructions in
Appendix C in the User's Manual (PDF file) provided on the Kyocera Digital Library CD-ROM.
9—Attach the Power Cord
1.
Check that the power switch is off.
2.
Plug one end of the power cord into the
receptacle at the back of the printer.
3.
Plug the other end into the wall outlet.
" is for a parallel (Centronics standard) interface. The one marked
Option Interface
Slot Cover
4. Setting Up and Interfacing
Rear Panel
Printer Cable
Power Cord
Clips
Power Cord
Receptacle
13