Left Needle - JUKI MO-2000QVP Instruction Manual

Threading 4/3 Thread OL
1
3
5
6
7
4
8
10
A
11
2
6
7
9
12
13
Left-hand needle, beige markings
Switch the machine off (power switch"0")
Place the spool on the spool holder pin as illustrated.
(1) Thread the thread guide which is located just
above the spool from back to front.
(2) Thread the thread guide No.1
(3) Route the thread in the groove.
(4) Put the thread under the thread guide plate.
(5) Thread the thread take-up cover (marked in
beige)
(6) Thread the thread guide (left-hand side).
(7) Thread the needle bar thread guide (left-hand
side).
(8) Turn the handwheel to align the " " marking on
it with the " " marking on the side of the front
cover.
(9) Set the right-/left-needle changeover lever to the
left needle side.
Be sure to move the right-/left-needle change-
over lever to the left needle side until it will go no
further.
(10) Lower the threading lever as far as it goes.
(11) Push the thread into section A with both hands.
(12) The thread automatically passes through the
needle eyelet by pushing the threading lever
upward.
(13) Pull out the thread by approximately 10 cm to
route it under the presser foot and draw it out
from its rear.
20