How To Use The Presser Foot; Inserting Needles - JUKI MO-2000QVP Instruction Manual

Using the machine
8.5mm
10mm
A
B
C
11

How to use the presser foot

Use the marker on the presser foot as a guide when placing
the material under the presser foot.
(F) Left needle position
(G) Right needle position
(H) Knife position (when the lower knife adjusting knob is set
at scale mark "1.5")
F The knife position represents the position at which the
G
material is cut.
H
Inserting the needles
Needles can be inserted quickly and easily with the practical
needle inserter (A).
Switch the machine off (Power switch to "0")
Disconnect machine from electricity supply.
Turn handwheel towards you until needles are fully raised.
Match the matching up marks on handwheel and side cover.
Lower the presser foot.
Using the small screwdriver, loosen the needle setscrews and
remove the needles (B).
Place the right-hand needle, flat side towards the back, into
the hole of the needle inserter and insert the needle as far as
possible into the needle clamp.
Tighten the setscrew lightly and then insert the left-hand nee-
dle in the same way and tighten both setscrews (C).