Changing The Wire Feed Rollers - EWM Taurus 401 Basic FKW Operating Instructions Manual
Hide thumbs
Also See for Taurus 401 Basic FKW:
- Operating instructions manual (74 pages) ,
- Operating instructions manual (41 pages) ,
- Operating instructions manual (61 pages)
Table of Contents
Advertisement
5.8.2.3
Changing the wire feed rollers
Unsatisfactory welding results due to faulty wire feeding!
Wire feed rollers must be suitable for the diameter of the wire and the material.
•
Check the roller label to verify that the rollers are suitable for the wire diameter.
Turn or change if necessary!
•
use V-groove rollers with for steel wires and other hard wires,
•
use U-groove rollers for aluminium wires and other soft, alloyed wires.
•
Slide new drive rollers into place so that the diameter of the wire used is visible on the drive roller.
•
Screw the drive rollers in place with knurled screws.
099-005230-EW501
02.04.2014
Design and function
NOTE
Figure 5-9
MIG/MAG welding
39
Advertisement
Table of Contents
Need help?
Do you have a question about the Taurus 401 Basic FKW and is the answer not in the manual?
Questions and answers