Welding Data Display - EWM Taurus 401 Basic FKW Operating Instructions Manual
Hide thumbs
Also See for Taurus 401 Basic FKW:
- Operating instructions manual (74 pages) ,
- Operating instructions manual (41 pages) ,
- Operating instructions manual (61 pages)
Table of Contents
Advertisement
Design and function
Shielding gas supply (shielding gas cylinder for welding machine)
5.7.4
Welding data display
The machine control displays show all welding parameters that are required by the welder. The lower
centre display shows the selected welding task (JOB number). The "parameter selection" (
button can be used to switch the display between welding voltage, welding performance and gas flow rate
(option).
What is shown on the displays depends, among other things, on the selected welding procedure and the
machine state (welding, power-saving mode, machine error).
MIG/MAG welding
Parameter
Welding current
Wire feed speed
Welding voltage
Welding performance
MMA welding
Parameter
Welding current
Welding voltage
Welding performance
32
Figure 5-5
Nominal values
Actual values
Nominal values
Actual values
Hold values
Hold values
) push-
099-005230-EW501
02.04.2014
Advertisement
Table of Contents
Need help?
Do you have a question about the Taurus 401 Basic FKW and is the answer not in the manual?
Questions and answers