Foscam FI9818W User Manual page 42

4.4.5 UPnP
The default UPnP status is closed. You can enable UPnP, then the camera's software will be configured
for port forwarding. Back to the "Device Status" panel, you can see the UPnP status:
The camera's software will be configured for port forwarding. There may be issues with your routers
security settings, and sometimes may error. We recommend you configure port forwarding manually on
your router.
4.4.6 Port
This camera supports HTTP Port. HTTP Port is used to access the camera remotely. If you want to
access the camera and view the video, the HTTP Port must both be configured correctly.
HTTP port: By default, the HTTP is set to 88. Also, they can be assigned with another port number
between 1 and 65535. But make sure they can not be conflict with other existing ports like 25, 21.
Another way to change the HTTP port NO.
Step 1: Open the IP Camera Tool, select the camera you would like to change the port of, right click on
the IP address, and click on "Network Configuration", this brings up the network configuration box as
flowing figures.
Shenzhen Foscam Intelligent Technology Co., Limited 40
Tel: 86 755 2674 5668 Fax: 86 755 2674 5168