Operating Instructions - Worx WU188 Manual

Symbols
To reduce the risk of injury, user must read instruction
manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Indoor use only
Do not expose to rain or water
Do not burn
Do not dispose of batteries. Return exhausted batteries to
your local collection or recycling point

Operating instructions

Note: Before using the tool, read the instruction book carefully.
INTeNded Use
The machine is intended for driving in and loosening screws as well as
for drilling in wood, metal and plastic.
BeFORe PUTTING INTO OPeRATION
—BATTeRY CHARGING
The battery charger supplied is matched to the Li-ion battery installed
in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging. When the
battery is empty, the machine is switched off by means of a protective
circuit: The chuck no longer rotates.
In a warm environment or after heavy use, the battery pack may
become too hot to permit charging. Allow time for the battery to cool
down before recharging.
When the battery is charged for the first time and after prolonged
storage, the battery will only accept approximately 60% charge.
However, after several charge and discharge cycles the battery will
accept a 100% charge.
—TO ReMOVe OR INsTALL BATTeRY PACK (see Fig. A)
Press the battery pack release button and remove the battery pack
from the tool. After recharge, slide the battery pack into tool's battery
port. A simple push and slight pressure will be sufficient.
7