Print Head Holder Does Not Move To The Position For Replacing - Canon mg 7100 series Online Manual

Print Head Holder Does Not Move to the Position for Replacing

Is the POWER lamp off?
Check1
Check if the POWER lamp is lit.
The print head holder will not move unless the power is on. If the POWER lamp is off, close the operation panel
and turn the machine on.
While the POWER lamp is flashing, the machine is initializing. Wait until the POWER lamp stops flashing and
remains lit, and then open the operation panel again.
Is an error message displayed on the touch screen?
Check2
Close the operation panel, follow the Support Code (error number) displayed in the error message to resolve the
error, and then reopen it. For details on how to resolve the error, refer to
Has the operation panel been left open for 10 minutes or longer?
Check3
If the operation panel is left open for more than 10 minutes, the print head holder moves to the position to protect
it to prevent the print head from drying out. Close and reopen the operation panel to return the print head holder
to the position for replacing.
Has the machine been printing continuously for a long period?
Check4
Close the operation panel, wait a while, then reopen it.
If the machine has been printing continuously for a long time, the print head holder may not move to the position
for replacing since the print head may overheat.
Note
• Opening the operation panel while printing moves the print head holder to the position to protect it.
Close the operation panel, and reopen it after printing finishes.
Support Code
95
List.