The Machine Cannot Be Detected In The Wireless Lan - Canon mg 7100 series Online Manual

The Machine Cannot Be Detected in the Wireless LAN

Make sure that the machine is turned on.
Check1
Is Change wireless/wired in LAN settings under Device settings set to
Check2
Disable LAN?
When the machine is connected to the computer temporarily using a USB
Check3
cable, make sure that the USB cable is connected properly.
When you set up the wireless LAN connection using a USB cable or change the wireless LAN settings using IJ
Network Tool, connect the machine and the computer securely.
Connecting the Machine to the Computer Using a USB Cable
Make sure that the machine setup is completed.
Check4
If not, perform setup according to the instructions on our website.
When using IJ Network Tool, click Update to search for the printer again.
Check5
Canon IJ Network Tool Screen
Make sure that the network settings in the printer are identical with those of the
Check6
access point.
Refer to the instruction manual provided with the access point or contact its manufacturer to check the access
point settings, and then modify the machine settings.
How to Set a WEP/WPA/WPA2 Key
Make sure that there is no obstruction.
Check7
Wireless communication between different rooms or floors is generally poor. Adjust the location of the devices.
Make sure that the machine is not place as far away from the access point.
Check8
The access point is located indoors within the effective range for wireless communication. Locate the machine
within 164 ft. / 50 m from the access point.
Make sure that there is no source of radio wave interference in your vicinity.
Check9
There may be a device such as a microwave oven using the same frequency bandwidth as the wireless station.
Place the wireless devices as far away from the interference source as possible.
Make sure that the network settings of the computer are correct.
Check10
Make sure that the computer can communicate with the printer and the access point over the wireless LAN.
Make sure that the firewall of the security software is disabled.
Check11
If the firewall function of your security software is turned on, a message may appear warning that Canon
software is attempting to access the network. If the warning message appears, set the security software to
always allow access.
If using any programs that switch the network environment, check their settings. Some programs will enable a
firewall by default.
31