Environmental Protection; Maintenance - Worx WU302 Manual

Working hints
1 If your power tool becomes too hot, set the speed to maximum and
run it with no load for 2-3 minutes to cool the motor.
2
Tungsten carbide drill bits should always be used for concrete and
masonry.
3
When drilling in metal, only use HSS drill bits in good condition.
4
Always use a magnetic bit holder when using short screwdriver bits.
5
When drilling steel where possible use a pilot hole before drilling a
large diameter hole.

Maintenance

Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.

Environmental protection

Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authorities or retailer for recycling advice.
8