Maintenance; Environmental Protection; Declaration Of Conformity - Worx WX121 Series Manual

it is in the middle position, the machine will lock the start-
stop switch. Put it where it needs to be turned and press
the button, the machine will start to rotate.
2. WHY DOES THE ELECTRIC DRILL STOP RUNNING
BEFORE THE SCREW IS TIGHTENED?
At this time, please adjust the torsion adjustment
ring between the frame and the chuck. The torsion
corresponding to position 1 is the smallest, and that
corresponding to position 20 is the largest.Position
specially for drilling holes This problem can be solved by
adjusting the torsion adjustment ring to a higher level.
3. WHY IS THE WORKING TIME OF THE SAME BAT-
TERY PACK SOMETIMES LONG AND SOMETIMES
SHORT?
As mentioned above, if a battery pack is left unused
for too long, its working time will be shortened. Such
situation will be improved after charging and using for
several times. Under doing heavy work, such as screw-
ing big screw into hard wood, the battery power will be
consumed very fast. Do not charge in the environment
below 0 C or above 40 C, which will also affect the
o o
performance of the battery pack.

6. MAINTENANCE

Be sure to pull out the battery before any repair work on
the machine.
No additional lubrication or special maintenance is
needed for your power tool. Do not use water or chemi-
cal detergent to clean your power tool. Wipe it with a
dry cloth. Tools should be kept in dry environment and
keep the motor vent clean. Try not to use it in dusty
environment.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage
of tool and battery is 0 C-45
O
The recommended ambient temperature range for the
charging system during charging is 0

7. ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.

8. DECLARATION OF CONFORMITY

We,
Positec Germany GmbH
Postfach 32 02 16, 50796 Cologne, Germany
On behalf of Positec declare that the product
Description Impact Drill
Type WX121 WX121.X (1-designation of machinery,
representative of Cordless Drill)
Function Drilling
Complies with the following directives,
2006/42/EC
C.
O
C-40 C.
O O
EN
17