Service Menu: Sub Menu 1 - Change Parameter; Meaning Of Service Menu Selection Items - Wincor Nixdorf BEETLE /moPOS Getting Started

Mobile pos solution

Hide thumbs Also See for BEETLE /moPOS:

Table of Contents

7.1.2 Service Menu: Sub Menu 1 - Change Parameter

Start Normal

Start without plugins

Start with Service

Change Parameter:

Reset Firmware Pa-

rameters to Defaults

BEETLE /moPOS "Getting Started"

LED Service Menu during BOOT and operational LED States

When selecting this menu item the POS Device HUB starts as usual.

When selecting this menu item the POS Device HUB starts as usual –

but without starting the additional customer plugins. This is very

helpful in case a customer plugin has a fault behavior making the

POS Device HUB not working properly. This may happen in case a

plugin is consuming so many processor time that the whole system is

working too slow for a reasonable usage. Then you may start the

POS Device HUB without starting plugins and deactivate the fault

plugin in the admin WebGUI.

Note: the changes done by this menu are only valid for the current

booting.

When selecting this menu item the POS Device HUB starts as usual

but the option "Print Service Report on Printer during BOOT" is acti-

vated. In this case additionally during boot (and also future boot

phases) the service report is printed on the configured receipt print-

er. You may disable again this option in the admin WebGUI of the

POS Device HUB

Note: the changes done by this menu item will be done permanently

This menu item restores all configuration parameters which are

changeable in the admin WebGUI to the defaults and starts the POS

device HUB. Defaults are e.g.:

Table of Contents

Show Quick Links

Table of Contents