Tail Assembly - SAB Goblin black thunder Instruction Manual

C
DETAIL A
Attaching H0082-S to the boom:
Pre-assemble the two boom spacers H0082-S with
the M3x20 socket set screw.
Insert into the boom tube completely done up.
Center the holes, then unscrew until there is contact with the walls
Lock everything with the adhesive.
Assemble H0040-S in the boom:
Before assembling the two parts in the boom we suggest tightening the
M2.5 screws into the two plastic parts to pre-thread them. In this way
when you will assemble the tail servo it will be easier to tighten the screws
into the plastic parts. Check the tail servo can fit, if necessary carefully sand
the hole.
Tail Servo Lock
(H0040-S)
DETAIL C
Locking Element

Tail Assembly

Double
Sided Tape
Tail Boom Assembly
Boom Thunder Black
(H0702-S)
Block Nut
(H0358-S)
Flat Head Cap
Boom Spacer
Screws M3x8mm
(H0082-S)
(HC134-S)
Double
Sided Tape
B
DETAIL B
Assemble H0045-S in the boom:
Before mounting H0045 on the boom we
suggest to first tighten the M2.5 screws into the
holes to thread them. In this way when you
assemble the part it will be easier to tighten the
screws.
Socket Head Cap
Screw M2.5x6mm
(HC018-S)
Set Screw
M3x20mm
(HC150-S)
Locking Element Tail Assembly .... X 2
Locking Element Tail
(H0041-S)
Note:
Chapter 12, Tail
BAG 13
A
Linkage Tail
Support
(H0045-S)
Metric Hex Nylon Nut M3
(HC206-S)
Page 23