SAB Goblin black thunder Instruction Manual page 12

Chapter 5, Transmission Assembly
BAG 3.1, BAG 3.2
Note:
When you tighten the collar (H0121-S) on the main
shaft, ensure there is no axial play.
Push down the main shaft while pulling up the
locking collar. Tighten the screw M4x22 at this time.
It is very important to lubricate these two
elements with a lubricant
( Dry Fluids Gear or similar).
Metric Hex
Nylon Nut M3
(HC206-S)
Socket Head Cap
Screw Shouldered
M3x18mm
(HC079-S)
Socket Head Cap Screw
Shouldered M4x24mm
(HC111-S)
Secondary Shaft
(H0157-S)
Note: Correct insertion of
the one-way pulley
Page 10
19T Drive Pinion
(H0156-S)
Main Gear
(H0405-S)
Socket Head Cap
Screw M4x22mm
(HC104-S)
Socket Head Cap Screw
Shouldered M2.5x19mm
(HC033-S)
Main Shaft
(H0122-S)
Metric Hex
Nylon Nut M4
(HC212-S)
Metric Hex
Nylon Nut M4
(HC212-S)
M4 Locking Collar
(H0121-S)
60T Pulley Assembly
(H0171-S)
Bearing
10x
(HC420-S)
One Way Bearing
10x
(HC442-S)
One Way Bearing
10x
(HC442-S)
Bearing
10x
(HC420-S)
Front Tail Pulley Assembly
(H0172-S)
Socket Head Cap
Screw M2x10mm
(HC010-S)
37T Pulley
(H0172-S)
Main Structure
Assembly 1
Bush One Way
(H0110-S)
eg: Microlube GL261
60T Pulley Assembly
(H0171-S)
Metric Hex Nylon
Nut M2.5
(HC200-S)
Washer 10x
(HC232-S)
The perfect play is 0.5mm
add or remove shim for this
15x4mm
14x12mm
60T Pulley
(H0171-S)
14x12mm
15x4mm
16x0.2mm