Installation Of Flybarless Unit And Rx - SAB Goblin black thunder Instruction Manual

Chapter 11, Installation Of Flybarless Unit and RX
BAG 9
FLYBARLESS CONTROL UNIT AND RX INSTALLATION
Figures 1 shows an example of installation of the flybarless control unit.
You can use short spacer H0727 ( Figure 2 ).
You can use long spacer H0043 ( Figure 3 ). This is typical if you want to put RX satellite under the control unit.
If you want to assembly RX under FBL
support. You can use H0043 [ 26mm ].
Flybarless Unit
Double-sided
Tape
[H0043]
RX
For Flybarless systems with a separate sensor, the sensor must be installed under the main plate (Figure 4).
In Figure 5 you can see the extension lead for the tail servo. It is very important to include a connector for fast
disassembly of the boom module.
The connector will prevent servo damage in case of boom separation during a crash.
Page 20
Slot for sensor cable
Flat Head Cap
Screw M3x8mm
(HC134-S)
Socket Head Cap
Screw M3x6mm
(HC044-S)
Support
Flybarless
(H0077-S)
Spacer Support
Flybarless
(H0727-S)
Socket Head Cap
Screw M3x6mm
(HC044-S)