Table of Contents
Advertisement
NOTES FOR ASSEMBLY
ADDITIONAL COMPONENTS REQUIRED
* Duct Fan 100-120mm Diameter, 5-10kg thrust.
* Landing gear system. ( P/N S0303 ).
* Battery for Duct Fan : 12S 5000mAh.
* ESC 160/200A.
* Batteries for RX / servos : 2S 2500mAh.
* Radio power system.
* 2 Wings servos (15x35 mm mini size, min. 10 KG/cm.
Possible to use also 20x40 standard size)
* 1 Canard servo (20x40 mm standard size, min. 20 KG/cm).
* 1 Steering system servo (15x35 mm Mini size, min. 6 KG/cm).
* Optional 2 Rudder servos (10x30 mm mini Wing, min. 6 KG/cm).
* Accessories, Extensions, Power Connectors.
NOTES FOR ASSEMBLY
Please refer to this manual for assembly instructions for this model. Follow the order of assembly indicated. The instructions are divided into chapters, which are structured in a way that each
step is based on the work done in the previous step. Changing the order of assembly may result in additional or unnecessary steps.
Use thread lockers and retaining compounds as indicated. In general, each bolt or screw that engages with a metal part requires thread lock.
It is necessary to pay attention to the symbols listed below:
Important
The assembly process is described in the following chapters. Each chapter provides you with the bag number you will need for that chapter. The information is printed in a red box in the upper right
corner of the page at the beginning of every chapter.
Use CA Glue
TOOLS AND ADHESIVES
*Drill with drill bits 2, 3, 4, 5mm.
*Small milling cutter for drill.
*Generic pliers.
*Hexagonal driver, size 1.5, 2, 2.5, 3 mm.
*Cyano-acrylate glue.
*Epoxy glue.
*Medium threadlocker (eg. Loctite 243).
*Soldering equipment (for electric wiring).
Sand and fit where
necessary
Use Epoxy Glue
BAGxx
Use Thread Locker
Medium Strength
( SAB HA116-S)
Indicates that for this assembly
phase you need materials that are:
BAG xxx.
Page 3
Advertisement
Table of Contents
