SAB Goblin black thunder Instruction Manual page 14

Chapter 5, Transmission Assembly
BAG 5
Bearing support (H0143-S)
Install H00142 after mounting the motor.
The motor shaft requires a centered
pulley. H0142 can not be used with an
8mm motor shaft.
21T Pulley
(H0175-21-S)
Install motor pulley after installing H0142.
(See page 17 for optional pulley selection).
Set Screw M5x20mm
(HC158-S)
Note for 6mm motor shaft
To maximize space for the batteries, it
is advisable to shorten the motor shaft.
Follow the dimensions given in this
drawing. For the cut, you can use an
electric tool like a "Dremel" with a cut-
off disc.
Additionally, ensure the motor shaft
has an appropriate 'flat' for one of the
set screws.
Page 12
Motor Mount
(H0142-S)
Socket Head Cap
Screw M3x8mm
(HC050-S)
Flanged Bearing
6x 13x5mm
(HC414-S)
Set Screw
M4x6mm
(HC153-S)
Button Head Cap
Screw M4x8mm
(HC098-S)
Bushing
6x 8x18mm
Spring
(H0176-S)
[HC310]
Use with 6mm
(HC315-S)
motor shaft.
Motor
Spring
[HC314]
(HC315-S)
Socket Head Cap
Screw M3x10mm
(HC056-S)
6mm
Metric Hex Nylon
Nut M5
(HC218-S)
Washer
5.3x 15x1mm
(HC188-S)
Socket Head Cap
Screw M3x10mm
(HC056-S)
Finishing Washer M3
(H0007-S)