Dismantle Guide - Galanz XQG60-A708E Service Manual

Attention：during the detection, for example: the failure occurs in the process of measurement, the
machine will not conduct the following programs unless the problem has been solved and proceed the
detection function again, it can finish all the detection function.
During the detection，press button "start\pause" or button "power" to stop or end detection program, it
won't work to press other buttons.
6．Dismantle guide
6.1.1 Attention: Please ensure to pull the plug or switch off the machine before dismantle and repair
①Please remove the two bolt in the back of the top
cover
1
②Pull back the top cover and take it out
①Take off the wiring harness in the lamp panel
②Follow and plus the arrow signal to take out the
2
cap( picture 1)
③Remove two bolts from the inlet box( picture 2)
④Pull up the control panel
①Remove the 6 bolts in control panel
3
②Take off the lamp panel from the top of the control
panel
①Remove the two bolts from top cover component and
take of the top cover
1
②Follow the arrow side to take off the distribution box
（picture 1） 。
③Remove the two bolt from inlet box（ picture 2） 。
①Remove the inlet sink and one bolt on the right
2
(picture 3)
Control panel
Distribution box
10
（1） （2）
picture３