Inlet Valve; Down Frame; Door; Door Seal Parts - Galanz XQG60-A708E Service Manual

①Remove the inlet hose and clip
3
①Remove the inlet hose(picture 4)
4
①Take of the inlet valve connection
②Remove two bolts from the back of the inlet valve
1
③Remove the hose clip and hose
① Using corns or screwdriver to open the bottom
dam-board(picture 5), remove the one bolt
1
②Using the screwdriver to open the dam-borad（picture
６） 。
①open the door completely
②loose the dorr seal spring （picture７） 。
1
③Remove two bolts from the door hinge, please beware
to hold the screw nut.(picture 8)
①remove the ourter box door seal ring spring (picture7)
②Take off the top cover
1
③Open the below dam-board cover and remove one
bolts inside and dam-board. Photo 9 &10)
①Take off the washing powder distribution box (picture
1)
② remove the control panel （ attention:follow the
2
instruction of removing control panel methods)
③Remove all the upside and down side bolts from the
front cover (picture 11& 12) and remove front cover
①Remove outer tub seal ring spring
3
②Ensure the weep hole from seal ring is backward with
reset. (picture13)

Inlet valve

DOWN FRAME

DOOR

DOOR SEAL PARTS

11
picture４
５ ６
７ ８
９
10
11 12
13