Emerson CF3000BS00 ORIGAMI Owner's Manual page 8

Figure 13
WARNING
!
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not oper-
ate fan until blades are in place. Noise and fan dam-
age could result.
4. After connections have been made, separate the
white and green wires from the black, blue and
yellow wires.
5. Carefully turn the wires upward and insert them up
through the open side of the hanger bracket and
into the outlet box. Push the green and white wires
into one side of the outlet box; push the black, blue
and yellow wires into the other side of the outlet
box.
HANGER
BRACKET
Figure 14
6. Screw the two 1-1/4" threaded studs (supplied)
into the tapped holes in the hanger bracket
(Figure 15).
SW105 RECEIVER
WHITE RECEIVER WIRE
BLACK RECEIVER WIRE
BLACK/WHITE
RECEIVER WIRE
WHITE FAN WIRE
BLACK FAN WIRE
DOWNROD
OUTLET BOX
RECEIVER
CEILING
COVER
BLACK
TO
SUPPLY
110V
WIRE
SUPPLY
WHITE SUPPLY
WIRE
BLUE RECEIVER WIRE
BLUE FAN WIRE
YELLOW RECEIVER WIRE
DO NOT USE
7. Lift the ceiling cover up to the threaded studs and
turn until studs protrude through the holes in the
ceiling cover (Figure 15).
8. Secure the ceiling cover in place by sliding
lockwashers (supplied) over the threaded studs and
installing the two knurled knobs (supplied).
(Figure 15.) Tighten the knurled knobs securely until
the ceiling cover fits snugly against the ceiling and the
hole in the ceiling cover is clear of the downrod. Your
fan is now wired to be turned on and off from the fan
switch.
1-1/4"
THREADED
STUD
KNURLED KNOB
Figure 15
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box
and not pinched between the ceiling cover and the
ceiling.
8
CEILING COVER
LOCKWASHER
WARNING
!
U.L. Model No.: CF3000