6�1 Trouble Shooting Chart - Wallenstein WX510 Operator's Manual

6.1 TROUBLE SHOOTING CHART
Always wear the appropriate safety gear when trouble shooting, performing maintenance or working around the
machine� This includes but is not limited to:
• Hard hat for protection to the head�
• Heavy gloves for hand protection�
PROBLEM
Cylinder rod moves slowly or
doesn't move.
Control handle doesn't go to
neutral after rod is fully
retracted.
Control handle goes to
neutral before rod is fully
retracted.
Control handle does't go to
neutral when released.
Cylinder stops on contact
with wood.
Wedge jumps.
Leaking hydraulic hose.
Leaking cylinder.
Engine related issues.
CAUSE
No pressurized
Oil filter plugged. Change filter.
hydraulic oil.
No pressurized
Low hydraulic oil level, top up
hydraulic oil
Wood jammed around Shut machine off and safely remove
wedge. wood.
Call technician, system relief setting
Not enough pressure.
may be low (below 2750 psi).
Check that choke is off, check
Low engine speed.
throttle is set to maximum.
Call technician, adjustment required
Detent set too tight.
with detent on valve.
Hydrualic fluid too
Allow machine to warm up.
cold.
Hydrualic fluid is too
Change hydraulic fluid and filter
old or contaminated.
Call technician, adjustment required
Detent set too loose.
with detent on valve.
Control may be Call technician, control may need
damaged. service or be replaced.
Second stage on pump Call technician, pump may need
not functioning. service or be replaced.
Wedge frame
Lubricate wedge frame wear plates.
jamming.
Hose worn or
Replace hose.
damaged.
Call technician, seal replacement
Seals worn.
may be required.
Refer to your engine instruction manual for specific trouble shooting instructions / requirements.
• Face mask for protection to the face and eyes�
• Safety shoes with slip resistant soles and steel toes
SOLUTION CAUTION
Ensure machine is off and cooled
down.
Ensure machine is off and cooled
down
Ensure machine is off
Ensure machine is off and call
hydraulic technician.
Ensure machine is off and call
hydraulic technician.
Ensure machine is off and cooled
down.
Ensure machine is off and call
hydraulic technician.
Ensure machine is off and call
hydraulic technician.
Ensure machine is off and call
hydraulic technician.
Ensure machine is off.
Ensure machine is off and cooled
down.
Ensure machine is off and call
hydraulic technician.
41