5�2�3 Hydraulic System Oil Filter; Trouble Shooting - Wallenstein WX510 Operator's Manual

5.2.3 HYDRAULIC SYSTEM OIL FILTER
1� review the Operator's Manual for the splitter�
2� Place all controls in neutral, stop and disable
engine before maintaining�
3� Allow the machine to cool before changing
the filter� Hot oil can cause burns if it con-
tacts exposed skin�
4� Place a pan under the filter head�
5� remove the oil filter, grasp the filter firmly
and turn counter-clockwise� An oil filter
wrench may be used if required�
6� Find and inspect the "O" ring, replace if dam-
aged or worn� Apply a light coat of oil to the
"O" ring�
7� Install the replacement filter, turn clockwise�
Snug up by hand and then tighten 1/2 turn�
8� run the machine for 1-2 minutes while op-
erating cylinder and check filter head for oil
leaks�
9� If leaks are found around the filter, tighten
slightly� If leaks persist repeat steps 6-9�
10� Check hydraulic reservoir oil level� Top up as
required�
11� Place the spilled oil in an approved container
and dispose of in a environmentally safe
manner�
6

TROUBLE SHOOTING

The Wallenstein Trailer Woodsplitter uses hydraulic power to move a hydraulic cylinder rod to split wood
or logs� It is a simple and reliable system that requires minimal maintenance�
In the following chart, we have listed many of the problems, causes and solutions to the problems that
you may encounter�
If you encounter a problem that is difficult to solve, even after having read through this trouble shooting
section, please call your local dealer, distributor or Wallenstein� Before you call, please have this Opera-
tor's Manual and the serial number from your Woodsplitter ready�
40
WX510
WX540
WX950
Fig. 23 HYDRAULIC SYSTEM FILTER