Fill Up Fuel Tank; Connecting The High Pressure Hose; Connecting The Water Supply - Nilfisk-ALTO NEPTUNE 5 SB FA Operating Instructions Manual

3.7

Fill up fuel tank

The fuel must be free from con-
tamination.
Tank capacity see chapter 9.4
Technical data.
3.8 Connecting the high
pressure hose
3.8.1 Machines with high
pressure hose reel
3.8.2 Machines without high
pressure hose reel
3.9 Connecting the water
supply
NOTE!
See chapter 9.4 Technical Data
for required quantity of water and
water pressure.
In the case of poor water quality
(sand, etc.), it is recommended
that an inlet water fi lter be in-
stalled.
1) Options / model variants
NOTE!
At temperatures below 8°C
(46°F), the fuel oil begins to so-
lidify (paraffi n precipitation). This
can lead to diffi culties in starting
the burner. Before the winter
1)
A
With the machine cold, turned
off and disconnected from power
supply:
1. Fill fuel tank from a clean con-
tainer with a fresh fuel (fuel oil
EL, or Diesel oil DIN 51 603),
or fuel type recommended by
your distributor.
months it is recommended that
a fuel conditioner/stabilizer be
added (available from the fuel
oil trade).
1. Connect the high pressure
hose quick connector to the
B
high pressure nipple (A) lo-
cated at the hose reel axle.
2. Place the high pressure hose
C
into the hose guide (B) and
ritain it with the clip.
3. Release the brake (C) on the
hose reel and wind up the
high pressure hose.
1. Connect the high pressure
hose quick connector to the
high pressure nipple located
at right rear of machine above
chemical tank.
1. Attach quick connect adapter
found with Owners Manual to
the water supply hose.
2. Rinse the water supply hose
briefl y in order to prevent sand
an other dirt particles entering
into the machine.
3. Attach water supply hose with
adapter to inlet quick connec-
tor.
4. Open water supply faucet.
Water supply hose should be
a reinforced hose and have a
minimum inside diameter of 3/4"
(19 mm).
NEPTUNE 5 SB FA
7