Fill Up Fuel Tank; Connecting The High Pressure Hose; Neptune - Nilfisk-ALTO NEPTUNE 5 Operating Instructions Manual

3.7

Fill up fuel tank

3.8 Connecting the high
pressure hose
3.8.1 Machines with high
pressure hose reel
3.8.2 Machines without high
pressure hose reel
1) Options / model variants
Original instruction
NOTE!
At temperatures below 8°C
(46°F), the fuel oil begins to so-
lidify (paraffi n precipitation). This
can lead to diffi culties in starting
the burner. Before the winter
months it is recommended that
a fuel conditioner/stabilizer be
added (available from the fuel
oil trade).
1)
A
With the machine cold, turned
off and disconnected from power
supply:
1. Fill fuel tank from a clean con-
tainer with a fresh fuel, heat-
ing oil, DIN 51603-1 (without
bio diesel) or Diesel EN 590
(Diesel with bio diesel content
up to 7%).
Diesel according to EN 590 (up
to 7% bio diesel) can be used
with the following restrictions:
Maximum storage time in High
Pressure Cleaner diesel tank: 1
month.
Diesel stored externally more
than 6 month is not allowed to
be filled into Nilfisk-ALTO High
Pressure Cleaners.
Diesel EN 590 is not recom-
mended for use in HPW's below
0 °C.
Diesel EN 590 exposed to the
surroundings must not be used.
The fuel must be free from con-
tamination.
Tank capacity see chapter 9.3
Technical data.
1. Connect the high pressure
hose quick connector to the
B
high pressure nipple (A) lo-
cated at the hose reel axle.
2. Place the high pressure hose
C
into the hose guide (B) and
ritain it with the clip.
3. Release the brake (C) on the
hose reel and wind up the
high pressure hose.
1. Connect the high pressure
hose quick connector to the
high pressure nipple located
at right rear of machine above
chemical tank.

NEPTUNE 5 / 7 / 8

english
7