Nilfisk-ALTO NEPTUNE 5 SB FA Operating Instructions Manual page 17

5.2.3 Buildings and Equipment
Task Accessories
General surfaces Foam injectors Stand-
ard lance
Curved lances
Metallic equipment
Tank cleaning
head
Detergents
Intensive
J25 Multi
Combi Active
Alkafoam
Disinfectant
DES 3000
Rusted or dam- Wet Sandblasting
ages surfaces prior equipment
to treatment
These are merely several examples of cleaning tasks that can be solved by a pressure washer in asso-
ciation with accessories and detergents. Each cleaning task is different. Please consult your local dealer
or Nilfi sk-ALTO representative in order to discuss the best solution for your own cleaning tasks.
1) Options / model variants
Method
1. Apply thick foam over the surfaces to be cleaned. Apply
on dry surfaces. Apply from top to bottom on vertical
surfaces. Let the foam act for up to 30 minutes for the
optimal effect.
2. Proceed with cleaning using the high pressure lance.
Use applicable accessories. Use high pressure to
dislodge large amounts of incrusted dirt or grime.
Use lower pressure and high water volume in order
to rapidly fl ush away loose dirt and rinse surfaces.
3. Apply DES 3000 disinfectant once the surfaces are
perfectly clean.
Areas covered by amounts of loose dirt, such as animal
remains in slaughterhouses, can be removed by using
high water fl ow to fl ush away the dirt to evacuation pits
or drains.
Tank cleaning heads can be used to clean barrels, vats,
mixing tanks etc. Cleaning heads may be hydraulically or
electrically powered and give the possibility for automatic
cleaning without a constant user.
1. Connect the sandblasting lance to the pressure
washer and place the suction tube in the sand.
2. Always wear protective equipment during sandblast-
ing.
3. Spray the surfaces to be treated with the mix of water
and sand. Rust, paint etc will be stripped off.
NEPTUNE 5 SB FA
15