Installing The Stroller Handles - Invacare Comet Owner's Operating And Maintenance Manual

BACK
WARNING
o
94 is the maximum back angle that can be used
with mini-tilt option.
5. Reinstall the front hex screw, washers and
coved washer and securely tighten with lock-
nut. Refer to FIGURE 16 for correct hardware
orientation.
6. Securely tighten the rear hex screw that secures
the back adjustment plate to the wheelchair
frame.
7. If wheelchair is equipped with cantilever arms,
adjust the angle of the cantilever arm so they
remain parallel to the ground/floor. Refer to US-
ING/INSTALLING/ADJUSTING CANTILEVER
ARMS in PROCEDURE 2 of this manual.
Seat Pan
Rear Hex
Screw
(Loosen,
but do not
Remove)
Back
Angle
Plate
Front Hex
Washer
Screw
Hole
No.
WARNING
o
94 is the maximum back angle that can be used
with the mini-tilt option.
FIGURE 16 - CHANGING THE BACK ANGLE
Coved Washer
Washer
Locknut
Wheelchair
Frame
Non-Mini Mini
Tilt Tilt
o
1 86 86
o
2 90 90
o
3 94 94
o
4 98 N/A
o
5 102 N/A
o
6 106 N/A

INSTALLING THE STROLLER HANDLES

(FIGURE 17)
1. Slide the stroller handle onto the back cane.
2. Make sure to line up the mounting holes of the
stroller handle and the back cane.
3. Press the button on the quick-release pin and
insert the quick-release pin through the stroller
handle and back cane.
4. Pull on the stroller handle to make sure it is
locked securely in place.
5. Repeat STEPS 1-4 for the opposite stroller
handle.
Button
Quick-
Release Pin
FIGURE 17 - INSTALLING THE STROLLER
o
o
o
41
PROCEDURE 4
Stroller
Handle
Back Cane
HANDLES
B
A
C
K
B
A
C
K