Adjusting The Seat Width- Non-Mini Tilt - Invacare Comet Owner's Operating And Maintenance Manual

PROCEDURE 3
ADJUSTING THE SEAT WIDTH-NON-MINI
TILT (FIGURE 4)
The following procedure must be performed by
an authorized Invacare dealer or qualified tech-
nician.
S
1. Remove the existing back upholstery and
E
spreader bar from the wheelchair. Refer to RE-
A
PLACING THE BACK UPHOLSTERY and RE-
T
PLACING THE SPREADER BAR in PROCE-
DURE 4 of this manual.
2. Remove the existing seat pan from the wheel-
chair. Refer to REPLACING THE SEAT PAN in
this section of the manual.
3. Remove the six (6) hex screws, washers and
coved washers that secure the three (3) exist-
ing crossmembers to the wheelchair frame.
Coved Washer
Hex Screws
WARNING
Crossmembers
Washer
FIGURE 4 - ADJUSTING THE SEAT WIDTH-
4. Install the new crossmembers onto the wheelchair
by reversing STEP 3. Refer to FIGURE 4 for cor-
rect hardware orientation and crossmember po-
sition.
5. Install the new seat pan onto the wheelchair.
Refer to REPLACING THE SEAT PAN in this
section of the manual.
6. Install the new back upholstery and spreader
bar onto the wheelchair. Refer to REPLACING
THE BACK UPHOLSTERY and REPLACING
THE SPREADER BAR in PROCEDURE 4 of
this manual.
Coved Washer
NON-MINI TILT
32
SEAT
Hex Screws
Washer
Wheelchair
Frame
S
E
A
T