Invacare Comet Owner's Operating And Maintenance Manual page 70

PROCEDURE 9
Footrests
ONE-PIECE FOOTBOARD OR ARTICULATING
FOOTPLATES.
1. Remove the four (4) socket screws that secure
C
the one-piece footboard or the articulating
O
footplates to the wheelchair.
N
2. Reposition the one-piece footboard or the ar-
V
ticulating footplates to the opposite end of the
E
wheelchair.
R
3. Adjust the one-piece footboard or the articulating
T
footplates to the necessary height, angle and
I
depth. Refer to ADJUSTING/INSTALLING THE
N
ONE-PIECE FOOTBOARD or ADJUSTING/
G
INSTALLING THE ARTICULATING FOOT-
PLATES in PROCEDURE 1 of this manual.
Coved Washer
Hex Screws
FIGURE 2 - REPOSITIONING THE CROSSMEMBERS FOR THE SWING UNDER FOOTBOARD
Coved Washer
Crossmembers
Washer
SWING UNDER/NON-SWING UNDER
FOOTBOARD.
1. Remove the four (4) hex screws, washers and
coved washers that secure the top two (2)
crossmembers to the wheelchair frame.
2. Switch the position of each crossmember (each
crossmember is opposite of where it was origi-
nally).
3. Secure the crossmembers to the wheelchair with
the existing four (4) hex screws, washers and
coved washers. Refer to FIGURE 2 for correct
hardware orientation.
70
CONVERTING
Hex Screws
Wheelchair
Frame