Oil Filter Maintenance - Telair ENERGY 4010D Use And Maintenance Manual

reduce air flow to engine. To prevent engine
malfunction, check the air filter regularly. If
the engine is used in a heavily dusty
environment, we suggest checking the air
filter every time before starting up the engine.
solvents with a low evaporation point for
cleaning the air filter cartridge, as this could
cause fires or explosions.
Never operate the engine without an air filter; the
engine would wear down quickly.
The filter element is located in a plastic box (fig.
29 ref. 1) To remove the filter element, open the
lid of the box by screwing out the suitable knob
(fig. 29 ref. 2).
After removing the lid, screw out the filter knob
(fig. 30 ref. 2) and take out the air filter (fig. 30
ref. 1).
Vers. 002
A clogged air filter will
Never use Diesel oil or
Energy 4010 D
GB
Slightly beat the element on a hard surface to
remove the excess dust or blow compressed air
inside out (fig. 31 ref. 1). Never brush the filter
element, as this would push dust in between the
fibres. Replace the filter element if excessively
dirty.

8.3.3 Oil filter maintenance

boiling oil. Spent oil should be collected and
disposed of
environment in
applicable law provisions in force.
maintenance every 500 running hours
To clean the engine oil filter cartridge, this must
be removed from its seat.
Screw out the closing plug (fig. 32 ref. 1).
Take the filter out of its seat (fig. 33 ref. 1).
Scalding hazard due to
without polluting
compliance with
Perform oil
the
the
filter
19