Error Messages - Canon dp-v3010 Instruction Manual

Error Messages

Calibration Failed to initialize the external sensor.
Calibration error.
Calibration is completed.
(Brightness setting is lower than target brightness.)
Failed to detect the external sensor.
Please check the connection of the sensor.
Network Communication error.
Invalid IP Address.
Invalid Subnet Mask.
Various settings, There is no capacity USB memory.
CDL export
Failed to write file.
(CDL Export) Number of files is over limit.
LUT, Various settings, (LUT Import) "LUT Type" is different.
CDL import (CDL Import) "File Type" is different.
Failed to read file.
Failed to Import.
No import file.
Hardware error Backlight error.
Fan error.
Panel error.
I/F error.
System error.
Input signal No Signal
Unsupported
"Input Configuration" is different from Payload.
78 Error Messages
Message Description and Action
See CA-310 and CA-210 instruction manual.
• Check the installation and connection of the
external sensor and retry (
• Perform matrix calibration of CA-310 and CA-210
( 29).
Set the "Luminance" in calibration again (
Correctly connect the external sensor to the USB
port of this main unit.
IP address may be in conflict or there may be a
network communication error. Check the network
environment.
Enter the correct IP address.
Enter the correct subnet mask.
Use another USB memory or delete the content of
the memory.
The USB memory may be defective or protected.
Check the USB memory.
Up to 1000 files can be exported.
Select the correct file format.
The USB memory may be defective or protected.
Check the USB memory.
There is an error in the file to be imported. Check the
file.
Check to see if the file has been imported to the
USB memory.
Turn off the main power once and then back on.
If the message persists, contact Canon Customer
Center.
Displayed when there is no video signal input.
Unsupported video signal is input. Check the
supported signal format (
Check the "Input Configuration" (
Information" ( 53) settings. Reset any incorrect
"Input Configuration" settings.
28).
38).
57).
40) and "Signal