Table of Contents
Advertisement
Marker Settings
This menu is used to configure various markers.
Item
Marker Preset
Aspect Marker
Enable
Mask
Aspect Ratio
Line
Line Width
44
OSD Menu
Setting Options (underline indicates factory default)
Customizes markers which are assigned to markers 1 to 5.
Marker 1 to 5
An aspect marker displays a range in accordance with the specified aspect ratio.
Note
Aspect marker is not displayed in the following cases:
• When there is no signal, unsupported signal, or a channel with "Input Configuration" not set is
selected
• When "H Delay"/"V Delay" is "On"
• When a "Test Pattern" is displayed
• When "Peaking 1" or "Peaking 2" is selected
Switches the aspect marker On, Off.
On, Off
Switches the mask color. Mask is the blanking area outside the range of the marker.
Black:
Half (50% gray):
Off: Turns mask off.
Sets the aspect ratio of the aspect marker.
16:9, 15:9, 14:9, 13:9, 4:3, 2.39:1, 2.35:1, 1.896:1, 1.85:1, 1.66:1, Variable
The aspect ratio can be entered as a numeric value when you select "Variable" (0.01:1 increments). The
grayed out slider becomes active and can be used to set the aspect ratio.
1.00:1 to 3.00:1 (1.78:1)
Active when "Black" or "Half" is selected for "Mask". Switches lines on mask On, Off.
On, Off
Sets the thickness of the aspect marker line.
Thick, Normal, Thin
Advertisement
Table of Contents
