Table of Contents
Advertisement
Item
Line Color
Sets the color of the aspect marker line.
White, Red, Green, Blue, Yellow, Cyan, Magenta
Line
Sets the brightness of the aspect marker line.
Brightness
High, Low
H Position
Changes horizontal position without changing the aspect.
-65 to 65 (0)
V Position
Changes vertical position without changing the aspect.
-35 to 35 (0)
Safety Zone Marker 1, 2 There are two types of safety zone marker: 1 and 2, which share the same settings. A safety zone
marker is used to set the safe zone of the image (actual displayed area) to check the image.
Enable
Switches the safety zone marker On, Off.
On, Off
Aspect Ratio
Sets the aspect ratio of the safety zone marker.
16:9, 15:9, 14:9, 13:9, 4:3, 2.39:1, 2.35:1, 1.896:1, 1.85:1, 1.66:1, Variable
The aspect ratio can be entered as a numeric value when you select "Variable" (0.01:1 increments). The
grayed out slider becomes active and can be used to set the aspect ratio.
1.00:1 to 3.00:1 (1.78:1)
Area Size
Sets the safety zone marker area size.
80%, 88%, 90%, 93%, Variable (%), Variable (dot)
When "Variable (%)" is selected, the grayed out "Rate (%)" becomes active. When "Variable (dot)" is
selected, the grayed out "Width (dot)" and "Height (dot)" become active. This can be set by moving the
slider.
Rate (%)
Becomes active when you select "Variable (%)" under the menu "Area Size". Move the slider to set the
displayed marker area size without changing the aspect ratio in 1 % increments.
50 to 100 (80)
Width (dot)
Becomes active when you select "Variable (dot)" under the menu "Area Size". Move the slider to set the
area width in 2 dot increment.
360 to 4096 (3276)
Height (dot)
Becomes active when you select "Variable (dot)" under the menu "Area Size". Move the slider to set the
area height in 2 dot increment.
240 to 2560 (1728)
Setting Options (underline indicates factory default)
Note
Safety zone marker is not displayed in the following cases:
• When there is no signal, unsupported signal, or a channel with "Input Configuration" not set is
selected
• When "H Delay"/"V Delay" is "On"
• When a "Test Pattern" is displayed
• When "Peaking 1" or "Peaking 2" is selected
Note
• When "Area Size" is set to "Variable (dot)", you cannot select "Aspect Ratio".
OSD Menu
45
Advertisement
Table of Contents
