Turning; Stopping; Height Of Cut; Before Mowing - Hayter SPIRIT 41 Electric Owner's Handbook Manual

OPERATING THE MOWER

Turning

Stopping

Height of Cut

305113
CS284

Before Mowing

1.14
To make a wide turn steer the mower with the handlebar whilst trav-
elling forward.
To make a tight turn apply downward pressure on the handlebar to
raise the front wheels of the mower just above ground level and steer
the mower using the handlebar in the required direction.
To prevent accidents do not raise the front of the mower exces-
sively when making a turn. Never raise the rear of the mower
when the motor is running.
Release the stop lever to stop the motor.
WARNING: AVOID ACCIDENTS - The cutterblade may contin-
ue to rotate after the mower is switched off
Move the height of cut lever sideways to disengage it from the locking
notch, then push forwards to lower or pull backwards to raise the height
of cut. Release the lever in the required position and ensure that it locks
firmly into one of the seven notch settings.
Always select a height of cut to suit operating conditions. Prevent
motor overloading and blockages by avoiding low cuts in long grass
conditions. Be prepared to make two cuts when the grass is long.
To prevent accidents thoroughly inspect the area and remove all
objects which when contacted by the mower cutterblade could
become dangerous projectiles. Inspect the area for hidden obstruc-
tions which when contacted by the cutterblade could risk health
and safety. Remember the location of these obstructions and
ensure that you mow around them.