Hayter SPIRIT 41 Electric Owner's Handbook Manual page 25

PROBLEM
Motor fails to start.
Motor will not stop.
Cutterblade runs on exces-
sively after switching
'OFF'.
TROUBLE
POSSIBLE FAULT
Mains supply socket dead.
RCCB tripped.
Plug pulled out of mains
socket or connector plug.
Fuse failure.
Supply cable damaged.
Cutterblade obstructed.
Faulty switch control unit.
Faulty brake unit.
SHOOTING
REMEDY
Test socket by plugging in anoth-
er appliance.
Remove mower plug and check
RCCB action. Check the supply
cable for any obvious signs of
damage and replace immediately
if defective. If no obvious faults
are found a serious fault is indi-
cated. Contact your
Dealer.
Re-engage plug.
Fit a new 13 amp fuse.
Disconnect from the mains and
check the supply cable for any ob-
vious signs of damage. Replace
immediately if defective.
Disconnect from the mains and
remove any obstructions.
Ensure switch lever has returned
to the 'OFF' position. Disconnect
from the mains and contact your
Hayter Dealer.
Contact your Hayter Dealer.
Hayter
1.25