Overloading Protection - Hayter SPIRIT 41 Electric Owner's Handbook Manual

OPERATING THE MOWER

Overloading Protection

Do not let the motor labour or slow down through being overloaded in
work. When this situation occurs, raise the front of the mower slightly
by bearing down on the handlebar, allow the motor to reach maximum
speed and proceed to mow at a slower pace. Alternatively readjust to a
higher cut position. If the motor continues to labour, switch off and
remove the plug from the mains supply. Remove and empty the grass-
bag. Examine the discharge chute and remove any blockage. Turn the
machine on its side and clear any obstruction from the cutterblade and
the underside of the mower deck. Place the machine upright and
replace the grassbag. Readjust to a higher cut position if necessary.
Restart the mower and proceed to mow at a pace which does not over-
load the mower.
IMPORTANT: PREVENT DAMAGE - DO NOT continue to
operate the motor in an overloaded condition. If this does occur,
stop mowing and allow the motor to run at maximum speed for
one minute. This will allow the motor to cool down to its normal
working temperature.
1.17