RADVision SCOPIA XT1000 User Manual page 57


Use registrar - run terminal registration at a SIP Registrar Server.

Server - enter SIP Registrar Server IP address.

Use Proxy - use a SIP Proxy Server.

Server - enter SIP Proxy Server IP address.

Server type - choose server type to connect to (e.g., CISCO UCM Microsoft LCS, etc.).

Protocol type - use the appropriate protocol (UDP/TCP).

Port - port for server signaling (default is 5060).
H.323
In this menu you can set:

Name H.323 (H.323 ID) - the name used by the terminal for registration to the
gatekeeper.

Number H.323 (E.164) - identifying number used by the terminal for registration to the
gatekeeper.

Refuse calls by IP address - Possibility to discard incoming calls by IP address, incoming
calls by alias accepted only (if registered to a gatekeeper).

Gatekeeper use and settings parameters.
Utilities
This menu contains the following configuration settings:

Password

Remote access

Licenses

Load default values
RADVISION | User Guide System Configuration Settings | 57