Audio-Video Management - RADVision SCOPIA XT1000 User Manual

Audio-Video Management

Video Input Management
From the home page, select Cameras; by pressing the RED function key on the remote
control you can move the camera, while pressing the other function keys you can select
different inputs. By pressing the remote control key OK you can toggle between different
inputs (the same function can be achieved by pressing the remote control key Inputs).
The desired video source must be connected to the system inputs on the back of
Note:
the equipment beforehand. For a correct setup of the function keys, see I/O
Connections section, Camera section.
During a connection it is also possible to control not only the local video camera's zoom and
panning functions but also those of the remote camera (if enabled). Use the remote control
keys Far and Near to select remote or local camera.
Using DVI-I IN
In the system rear panel there is a DVI-I input to connect a personal computer. For a correct
cabling, see the cabling diagram. Correct use of the DVI-I implies that the video PC
configuration has been set (setting: screen properties) with one of the following picture
frequency limits (or refresh frequencies).
Resolution
640 x 480
800 x 600
1024 x 768
1280 x 768
1280 x 1024
1440 x 900
1600 x 1200
1920 x 1200
RADVISION | User Guide
Refresh Frequency (Hz)
60, 72, 75, 85
56, 60, 72, 75, 85
60, 70, 72, 75, 85
60, 75
60, 67, 70, 72, 75, 76, 85
60
60
60
Call Management | 39