RADVision SCOPIA XT1000 User Manual page 43

changed to control with one remote control more systems in the same room avoiding
interferences. To do this, you must change the code inside the system (in this menu),
and then accordingly change the remote control code by pressing simultaneously the
RED and GREEN function keys on the remote control. The ON/OFF function key on the
remote control will become red, and you can insert the remote control code (two
characters from 01 to 99).
Call-Answer Mode
This menu contains the following configuration settings:

Mute - Selected, at the start-up and after each disconnection system will not transmit
audio, an icon will be displayed in the local and remote terminals.

Do Not Disturb - Selected, at the start-up and after each disconnection system will not
accept incoming calls (system busy for the caller), an icon will be displayed in the local
terminal.

Video Privacy - selected, at the start-up and after each disconnection system will no
longer transmit local video, and a predefined image will be sent; an icon will be
displayed in the local terminal.

Confirm disconnection - Enable/disable confirmation requests for call disconnection.

Automatic answer: - Enable/disable the automatic answer function, after the selected
number of rings. You may choose to enable the automatic answer always, never or
never if another call is already in place.

Ringing Volume - To set the ringing volume.

Volume - To set the default system audio volume.
Diagnostics
This menu allows getting information about:

Software version: all information about software modules.

Audio I/O: all information useful to establish whether Audio interfaces are properly
working, including two tests (local tone generation, local tone transmission to remote).
To access diagnostics information about the calls, press the help key on the
Note:
remote control.
RADVISION | User Guide System Configuration Settings | 43