Trainmaster Command Control Operations; Operating Your Locomotive In The Command Control Environment - Lionel 2343c Non-PoweredF-3 B-Unit Owner's Manual

TrainMaster Command Control operations

TrainMaster Command Control operations
T rainMaster Command Control is the advanced model railroad control system from Lionel.
To operate your locomotive in the Command Control environment, you need a Command
Base (available separately, 6-12911) and a CAB-1 Remote Controller (available separately,
6-12868).
Your commands are sent by the CAB-1 Remote Controller to the Command Base, which
then translates the command into digital code. That code is sent through the outside rails to
your locomotive, which will not respond until it recognizes its unique ID#. TrainMaster
Command Control gives you the power to operate multiple Command-equipped locomotives
on the same track at the same time.
Keep in mind that track power is like gasoline in the tank of a car—it gives you the power
to go places, but it doesn't tell you where to go or how fast to get there.

Operating your locomotive in the Command Control environment

1. Turn off track power and plug-in the Command Base. Be sure that the
Command Base is connected to the outside rail or to the Common/Ground/U terminal on
your track power supply.
2. Place your locomotive on Lionel or Lionel-compatible O-31 or larger
track.
3. Increase track voltage to full power (19 volts AC). On PowerMasters, slide the
CMD/CONV switch to CMD. Program Track Power Controllers to Command Control
operation.
4. Press ENG and 1 to address the non-powered B-unit with your CAB-1
Remote Controller. Press TR and 9 to address the unit as part of the factory-
programmed lash-up. Your non-powered B-unit comes programmed with an ENG ID# of 1
and a TR ID# of 9. To change the ID#, see pages 7 and 8.
5. Throttle up and move 'em out! Your locomotive will respond to every command from
your CAB-1 Remote Controller.
5