Setting The Picture Quality/Recording Time - Pioneer DVR-645H-S Operating Instructions Manual

DVR645H_WY_EN.book 59 ページ ２００６年７月５日 水曜日 午前１０時２５分
Recording
During playback or when a menu is being
displayed on-screen, the sound and video is
always routed to your TV and is unaffected by
the TV/DVD mode setting.
Note that the recorder must be connected to
your TV using a SCART cable to be able to
use this feature.
TV/DVD
• Switch between TV mode and
DVD mode.
Setting the picture quality/
recording time
DVD (VR) DVD (Video) DVD+R DVD+RW DVD-RAM
HDD
Before starting a recording, you will usually
want to set the picture quality/recording
time. There are six standard settings
available, which allow you to choose a
balance between picture quality and
recording time.
When Manual Recording is set to On (see
Manual Recording on page 139), a further
option will be available ( MN1 to MN32 or
LPCM , depending on what you set).
When recording to DVD+R/+RW, SLP is the
longest recording time available. If you
select SEP or MN1 to MN3 , the recording
mode will automatically revert to SLP .
Note
1 Audio is recorded in 16-bit Linear PCM format, video is recorded at XP quality. When recording a bilingual broad-
cast, select which audio channel to record (see Bilingual Recording on page 136).
REC MODE
SHIFT
• Press repeatedly to select
+
the recording quality.
• XP – High quality setting, gives about
one hour of recording time on a DVD
disc.
• SP (Standard Play) – Default quality,
used for most applications, gives about
two hours of recording time on a DVD.
• LP (Long Play) – Lower video quality than
SP, but doubles the recording time on a
DVD to about four hours.
• EP (Extended Play) – Lower quality than
LP, but gives about six hours of
recording time on a DVD disc.
• SLP (Super Long Play) – Lower quality
than EP, but gives about eight hours of
recording time on a DVD disc.
• SEP (Super Extended Play) – Lowest
video quality but gives about ten hours of
recording time on a DVD disc.
• MN1 to MN32 / LPCM
Linear PCM (available only when manual
recording is on)
The setting is indicated in the front panel
display, and shown on-screen together with
the recording time for a blank recordable
disc. If a recordable disc is loaded, the
approximate remaining recording time for
that disc is also shown. (Note that if the On
Screen Display setting (see On Screen
Display on page 143) is Off then this
information is not displayed.)
06
1
– Manual /
59
En