10
Chapter 1 About Avaya 7406 Digital Mobile Handset
Mounting Bracket
Mounting
bracket
Avaya 7406 Digital Mobile Handset Pre-installation Programming
Before connecting the Avaya 7406 Digital Mobile Handset base station to your system, you must
set up system programming for the handset lines.
Have the system administrator set up this programming:
1
Program Handsfree to Auto.
2
Program a maximum of three lines to each handset.
3
Assign Ring & Appear on the lines you assign to the handset.
Note: Appear only does not allow the handset to wake from Handset Asleep
mode.
4
Set the Page zone to None.
Note: Handsets can send Page announcements, but they cannot receive them.
5
Set DND on Busy to Yes if you do not want your calls interrupted with a ring tone when a
second call comes in. Instead, the button flashes, indicating an incoming call.
6
Other telephone programming is the same as for the M7310 telephone, with the exception of
the memory key locations.
Before you start
•
Ensure there is an AC power outlet within 1.5 meters (5 feet) of the base station location.
NN40110-300
NN40110-300
Notches match to bracket.