Faqs - Aztech WL590E User Manual

FAQs

1. Why can't I access the Web UI of my WL590E?
 Ensure that the Ethernet cable is properly connecting your WL590E's
and Desktop/computer through both of the device's Ethernet ports.
 You may turn-off / disable the wireless adapter of your computer (if
applicable) and launch a Web browser. It should redirect you to
User Interface of the WL590E (If in any case it does not type
http://10.0.10.254 on your Web browser Ex: Internet Explorer, Firefox,
or Chrome etc.)
2. What if I want to change some of the configurations set on my WL590E
after it has been previously configured and connected to my wireless
AP/Router?
 If you are connected to the WL590E's wireless network, you may just
open your Web browser and type http://10.0.10.254 on the address
bar to get to the Web user interface.
 Another way is to connect your desktop/PC to the WL590E using an
Ethernet cable, and type http://10.0.10.254 in the address bar to get
to the Web user interface.
3. Will the WL590E increase the range and throughput of my wireless
AP/Router?
The WL590E will extend the range of your wireless AP/router, but it will
NOT increase the throughput. All repeaters will sacrifice half of the
bandwidth available from the primary router for all of the clients
wirelessly connected to the repeater. This is a result of the repeater
taking turns talking to not just one partner, but to two, and having to
relay the traffic between them.
User Manual
Page 33 of 40