Securing Nuts And Bolts; Clutch Cable Adjustment; Lubrication; Cutterblade Removal - Hayter Harrier 41 series Owner's Handbook Manual

MOWER MAINTENANCE
Securing Nuts & Bolts
Regularly check that all securing nuts and bolts are tight.
Replace missing or damaged items immediately.

Clutch Cable Adjustment

At any time the operator feels that the machine is loosing
drive:
1. Stop the engine.
progressively engage the clutch lever until the rear
rollers lock, at this point the clutch lever should be
3. If the distance between the clutch lever and handlebar
with the black plastic cable adjuster. To regain the
4. Note this is a temporary adjustment and at the nearest
opportunity a service should be carried out to ensure
clutch is set correctly. This adjustment should be done
using the metal adjuster at the control with the plastic
adjuster reset fully wound in. When the spring is set
tighten the inner lock nut to secure position. (Refer
60mm

Lubrication

Lubricate the wheels, pivot points and linkages with
Apply a good quality medium grease to the inner control
ing.

Cutterblade Removal

Drain the fuel by running the engine until the fuel tank
is empty and the engine stops. Remove the spark plug
lead and allow the engine to cool. Turn the mower on its
left hand side and ensure that the air cleaner side of the
engine is uppermost.
Firmly grip the end of the cutterblade with a gloved hand
and remove the bolt, spring washer and distance piece
To prevent accidents never work on the cutterblade
unless the spark plug lead has been removed. The
cutterblade has sharp edges. ALWAYS wear strong
gloves to protect your hands when working on the
cutterblade. DO NOT rotate tools towards the cutting
edges to avoid the risk of injury should the tool slip.
ALWAYS use genuine Hayter replacement parts.
Clutch lever
fully engaged
Tighten the inner
nut when the cable
spring is set.
1
Metal
adjuster
The condition of the cutterblade and its mounting
arrangement should be checked regularly for signs of
wear or damage. Ensure that the cutterblade is not bent
or cracked.
-
A damaged cutterblade that is out of balance will vibrate
cutterblade.
Regularly check that the bolt securing the cutterblade is
To prevent injury it is wise to seek assistance when
turning the mower on its side.
(Refer

Cutterblade Assembly

Assemble the cutterblade with the turned up edges facing
towards the engine. Secure the cutterblade using the bolt
13mm
extension
Clutch spring
12
(Refer
3
2
1